How to successfully apply my acrylic wall paint?

We are searching data for your request:

Forums and discussions:

Manuals and reference books:

Data from registers:

Wait the end of the search in all databases.
Upon completion, a link will appear to access the found materials.

Fancy a new mural to modernize or give a new look to your interior? To help you succeed in your painting project, the editorial team invites you to discover the different steps to follow for a successful application of acrylic paint. From the preparation of the site, to the choice of material through the passage of the roller, decided to take stock.

Protect your site

A can of paint spilled on the floor, a piece of furniture or clothes stained by paint splashes ... and there it is drama! To avoid any material or bodily damage, you will understand, some golden rules must be observed among which the protection of your site.

First step therefore, start by emptying your room: from furniture, to curtains, passing through carpets, unclutter the space as much as possible and place a plastic sheet on the ground. If this is not possible, place your furniture in the center of the room and also cover it with a tarp or old sheets. Also bring comfortable clothes that do not fear splashing, think of a bandana or cap to protect your hair. And, if necessary, wear protective glasses and latex gloves. Once these rules are respected, you can get started on your site!

Prepare the support to paint

For an impeccable result, remember to prepare the surface to be painted. This step is certainly a bit tedious, you will avoid getting imperfect walls that reveal the defects. Depending on the condition of your walls, wash them from bottom to top with a mild detergent diluted in water and finish by rinsing with clear water and drying completely.

Are your walls cracked? Open them as much as possible with a scraper then fill them with plaster then when everything is dry, sand! And, if your old paint is peeling off, remove it with a wire brush and then sand the surface with sandpaper.

Choose a suitable material

Rollers that are too thin or too thick, brushes that lose their hair… think about the choice of your material which must be adapted to the quality of the paint chosen. For a better grip, opt for a conical brush with long synthetic bristles attached to the handle and don't forget to bring a tray with a grid to drain the excess paint before passing the roller.

For plinths and flat surfaces, prefer flat brushes and for moldings and corners, round brushes. Also consider purchasing protective tape and a stepladder.

The passage of the roller

Before you can get started, do not neglect the step of the undercoat for good adhesion to the support then, when the surface is dry apply adhesive tape which will prevent you from overflowing. This step done, it will be a matter of dosing the paint on your roller. Beforehand, you will have taken the time to assess the amount of paint to use.

To do this, once your paint has been mixed, dip the roller in half and remove the excess using the grid. In case of drips, do not panic! If the paint is not yet dry, iron it with a roller to spread it well. If it is dry, it will be necessary to sand and apply a new coat of paint.